For BMW 325i 328xi 135i 328i 128i 335i 330i 325xi 330xi X1 335i xDrive Fuel Pump

Description

The Function of the fuel pump is to supply fuel at a certain pressure to the engine fuel injection system.
However,the fuel pump have a limited life.If you notice any of the following signs with your car:
(1).Engine Sputtering at High Speeds
(2).Decreased Fuel Pressure
(3).Losing Power when the Vehicle is under Stress
(4).Inability to accelerate
(5).Decreasing Gas Mileage
(6).Engine Not Starting
This may indicate that you need to replace the fuel pump
Fuel Pump Replacement Guideline:
Please Note the following before replacing the fuel pump:
1.Ensure that you are in a well ventilated and level work area.
For BMW 325i 328xi 135i 328i 128i 335i 330i 325xi 330xi X1 335i xDrive Fuel Pump
The Function of the fuel pump
is to supply fuel at a certain pressure to the engine fuel injection system.
However,the fuel pump have a limited life.If you notice any of the following
signs
with your car:
(1).Engine Sputtering at High Speeds
(2).Decreased Fuel Pressure
(3).Losing Power when the Vehicle is under Stress
(4).Inability to accelerate
(5).Decreasing Gas Mileage
(6).Engine Not Starting
This may indicate that you need to replace the fuel pump
Fuel Pump Replacement Guideline
:
Please Note
the following before replacing the fuel pump:
1.Ensure that you are in a well ventilated and level work area.
2.Use approved safety glasses or goggles when working on any motor vehicle.
3.The gasoline is sucked out of the tank and stored in a container dedicated to gasoline.
Picture(A)
Disconnect the ground (
negative
) cable of the battery and ensure that it does not accidentally spark while working.
Picture(
B
)
Locate and remove gas tank filler neck mounting bolts or remove the filler tube from the tank. This will aid the fuel removal especially if you had problems accessing through the filler neck.
Picture(
C
)
Located the electrical connector for the fuel pump and fuel level sender which will be in the same wiring harness. If access if difficult or you can't see them wait until the tank is lowered slightly to undo the connector. Inspect electrical connector for burns or heated spots and replace if damaged. A burned connector can cause a pump to fail intermittently.
Picture(
D
)
There will be fuel vapor lines as part of the EVAP system these will need to be removed or disconnected.
Picture(
E
)
Locate and release tank holder supports, there are two in most cases. Remove the mounting bolts at this point the tank will become loose but may not come out.
Picture(
F
)
Lower the tank and release top mounted fuel lines or electrical connectors if any. Continue to remove the tank.
Picture(
G
)
Remove the tank, this will expose the fuel pump retainer ring. Use an aerosol cleaner to remove dirt and debris from the area. This will keep the inside of the fuel tank clean when performing the repair.
Picture(
H
)
Remove fuel pump mounting bolts or retainer ring to access the fuel pump module and remove the unit. Use a hammer and punch to remove the ring counterclockwise.
Picture(
I
)
Remove the fuel pump which will be attached to the mounting plate or positioned down inside the tank held by plastic retainer clips.
Picture(
J
)
Remove the fuel pump from the tank.
table#Attrid1265347 {border-collapse:separate} table#Attrid1265347 tr:last-child td:last-child{border-bottom-right-radius: 10px;} table#Attrid1265347 tr:last-child td:first-child{border-bottom-left-radius: 10px;} table#Attrid1265347 tr:nth-of-type(1n){} table#Attrid1265347 tr:nth-of-type(2n){} table#Attrid1265347 td{padding: 3px;} table#Attrid1265347{font-size:12px !important;font-family:Arial !important;color:#4c4c4c !important;text-align:left !important;} table#Attrid1265347 td:first-child{font-weight: 900; !important;;padding:3px;border:1px none ;} #m_pre1265347{border:1px none ;overflow: hidden;border-radius: 10px;}
Item Specifics
Fuel Pump Type
Electrical
Compatible Fuel
Gas
PSI
130-160
Gallons Per Hour (GPH)
70-75
Placement on Vehicle
Rear
Please Note
w/N52 Engine Code
Type
Turbine
Outlet Type
Quick Connect
Outlet Size
3/8
Inlet Type
Strainer
Outlet Count
1
Inlet Count
1
Terminal Type
Round
Pin Count
2
Terminal Gender
Female
Connector Shape
Oval
Connector Gender
Male
Internal Or External Strainer
Internal
In Tank or External
In Tank
Wiring Harness Included
No
Condition
New
Voltage
12 vDC
Gasket or Seal Included
Yes
Float Included
Yes
Package Contents
Fuel Pump Module Assembly w/Float Arm,Seal
Interchange Part Number
E8688M
Other Part Number
SP6671M,SP5009M
Cross Part Number
P76486M,FG0935,FG0917
Superseded Part Number
16147163298,228235018007Z
Fitment Type
Direct Replacement
Warranty
2 Year
Black Pressure Sensor Included
No
Color
White
Custom Bundle
No
OE Spec or Performance/Custom
OE Spec
Modified Item
No
Mounting Hardware Included
No
Brand
Fuel_Kingparts
UPC
Does not apply
Manufacturer Part Number
KF11693202ING
Payment
We only accept payment through PayPal.
Shipping
All domestic orders will be shipped via USPS, UPS or Fedex from our US warehouse and usually arrives to your door in about 2-7 business days.
Returns
All of our brand new items come with a 60-Days money-back guarantee.
Contact Us
Any question, please contact us by email on working days.
Warning
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
Best Sales
For Dodge Ram 1500 V6 3.7L V8 4.7L 5.7L Dodge Ram 2500 3500 V8 5.7L Fuel Pump
USD 62.99
For 2009-2010 Ford F-150 5.4L 4.6L 2011-2014 F-150 3.7L 5.0L 6.2L Fuel Pump
USD 58.99
For 2006-2010 Hyundai Sonata V6 3.3L 2006-2007 Hyundai Sonata L4 2.4L Fuel Pump
USD 59.99
For Pontiac G6 Chevy Malibu 2.4L 3.5L 3.6L 3.9L Saturn Aura 2.4L 3.5L Fuel Pump
USD 68.99
For 2005-2008 Ford F-150 4.2L 2004-2008 Ford F-150 4.6L 5.4L Fuel Pump
USD 43.99
Newly Listed
For 2012-2015 Buick LaCrosse 3.6L 2013-2015 Buick Regal Cadillac XTS Fuel Pump
USD 80.99
For Kawasaki NINJA ZX-6R ZX6R 2007 2008 2009 2010 2011-2016 Fuel Pump Filter
USD 14.49
For 2006-12 Mitsubishi Eclipse L4 2.4L 2006-12 Mitsubishi Galant 2.4L Fuel Pump
USD 65.99
For Mercury Marine 3.8L 4.3L 5.3L Fuel Pump Assembly 18-7284 41141A2 862077A1
USD 62.49
For 2008 2009 Cadillac CTS V6 3.6L Fuel Pump Electric E3798M
USD 71.19
Terms & Contact
Payment Policy
Shipping Policy
Return Policy
FAQ
About Us
For BMW 325i 328xi 135i 328i 128i 335i 330i 325xi 330xi X1 335i xDrive Fuel Pump
The Function of the fuel pump
is to supply fuel at a certain pressure to the engine fuel injection system.
However,the fuel pump have a limited life.If you notice any of the following
signs
with your car:
(1).Engine Sputtering at High Speeds
(2).Decreased Fuel Pressure
(3).Losing Power when the Vehicle is under Stress
(4).Inability to accelerate
(5).Decreasing Gas Mileage
(6).Engine Not Starting
This may indicate that you need to replace the fuel pump
Fuel Pump Replacement Guideline
:
Please Note
the following before replacing the fuel pump:
1.Ensure that you are in a well ventilated and level work area.
2.Use approved safety glasses or goggles when working on any motor vehicle.
3.The gasoline is sucked out of the tank and stored in a container dedicated to gasoline.
Picture(A)
Disconnect the ground (
negative
) cable of the battery and ensure that it does not accidentally spark while working.
Picture(
B
)
Locate and remove gas tank filler neck mounting bolts or remove the filler tube from the tank. This will aid the fuel removal especially if you had problems accessing through the filler neck.
Picture(
C
)
Located the electrical connector for the fuel pump and fuel level sender which will be in the same wiring harness. If access if difficult or you can't see them wait until the tank is lowered slightly to undo the connector. Inspect electrical connector for burns or heated spots and replace if damaged. A burned connector can cause a pump to fail intermittently.
Picture(
D
)
There will be fuel vapor lines as part of the EVAP system these will need to be removed or disconnected.
Picture(
E
)
Locate and release tank holder supports, there are two in most cases. Remove the mounting bolts at this point the tank will become loose but may not come out.
Picture(
F
)
Lower the tank and release top mounted fuel lines or electrical connectors if any. Continue to remove the tank.
Picture(
G
)
Remove the tank, this will expose the fuel pump retainer ring. Use an aerosol cleaner to remove dirt and debris from the area. This will keep the inside of the fuel tank clean when performing the repair.
Picture(
H
)
Remove fuel pump mounting bolts or retainer ring to access the fuel pump module and remove the unit. Use a hammer and punch to remove the ring counterclockwise.
Picture(
I
)
Remove the fuel pump which will be attached to the mounting plate or positioned down inside the tank held by plastic retainer clips.
Picture(
J
)
Remove the fuel pump from the tank.
table#Attrid1265351 {border-collapse:separate} table#Attrid1265351 tr:last-child td:last-child{border-bottom-right-radius: 5px;} table#Attrid1265351 tr:last-child td:first-child{border-bottom-left-radius: 5px;} table#Attrid1265351 tr:nth-of-type(1n){padding: 5px!important;background:#ffffff;} table#Attrid1265351 tr:nth-of-type(2n){padding: 5px!important;background:#f7fffb;} table#Attrid1265351 td div{padding: 5px;text-align:;} table#Attrid1265351 {font-family:Arial !important;font-size:16px !important;color:#000000 !important;text-align:left !important;} table#Attrid1265351 td:first-child{} table#Attrid1265351 td{padding:12px;border:1px solid #000000;}
Item Specifics
Fuel Pump Type :
Electrical
Compatible Fuel :
Gas
PSI :
130-160
Gallons Per Hour (GPH) :
70-75
Placement on Vehicle :
Rear
Please Note :
w/N52 Engine Code
Type :
Turbine
Outlet Type :
Quick Connect
Outlet Size :
3/8
Inlet Type :
Strainer
Outlet Count :
1
Inlet Count :
1
Terminal Type :
Round
Pin Count :
2
Terminal Gender :
Female
Connector Shape :
Oval
Connector Gender :
Male
Internal Or External Strainer :
Internal
In Tank or External :
In Tank
Wiring Harness Included :
No
Condition :
New
Voltage :
12 vDC
Gasket or Seal Included :
Yes
Float Included :
Yes
Package Contents :
Fuel Pump Module Assembly w/Float Arm,Seal
Interchange Part Number :
E8688M
Other Part Number :
SP6671M,SP5009M
Cross Part Number :
P76486M,FG0935,FG0917
Superseded Part Number :
16147163298,228235018007Z
Fitment Type :
Direct Replacement
Warranty :
2 Year
Black Pressure Sensor Included :
No
Color :
White
Custom Bundle :
No
OE Spec or Performance/Custom :
OE Spec
Modified Item :
No
Mounting Hardware Included :
No
Brand :
Fuel_Kingparts
Manufacturer Part Number :
KF11693202ING
Payment
Shipping
Returns
Contact Us
Warning
We only accept payment through PayPal.
All domestic orders will be shipped via USPS, UPS or Fedex from our US warehouse and usually arrives to your door in about 2-7 business days.
All of our brand new items come with a 60-Days money-back guarantee.
Any question, please contact us by email on working days.
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
All rights reserved.